Powerplants > Olds Powered
Need some measurements
sreta:
Hello guys!
I'm trying to fabricate the aluminum thermostat housing and I need to know the total height and the angle of the housing. I'm talking about the almost vertical type of housing which is specific for TA. So, if someone can take the measurements I will really appreciate it.
Thanks in advance
sreta:
Pic
Wallington:
https://www.ebay.com/itm/144144477848?hash=item218fae2e98:g:xJAAAOSwuZthDvOa
https://www.ebay.com/itm/293679265766?hash=item4460a5f7e6:g:6UUAAOSwpV9fLElL
sreta:
Thanks Ben! But I'm almost done with this little project so I can't give up now. The next step is to weld these two pieces together and I need to know the right position.
Wallington:
I can't find my spare, which makes me think I probably sold it and that's a worry.
The other is on my car, where I may be tomorrow. Can try and check but close to impossible to get any accurate figures with hoses on and my engine is busier than stock.
Unlike the standard 45 deg water neck, this version also tilts towards the radiator hose side.
Olds water neck 77-79 GM NOS 547083 (7) by Aus78Formula, on Flickr
http://transamcountry.com/community/index.php?topic=83571.0
Navigation
[0] Message Index
[#] Next page
Go to full version