« previous next »
Pages: [1]

Author Topic: Bulkhead Connector Question  (Read 494 times)

Brandon_78TransAm

  • Active Forum Member
  • *
  • Posts: 64
Bulkhead Connector Question
« on: November 11, 2022, 02:01:40 PM »
I have a 78 w/ Pontiac 400 and I have determined my engine harness is toast, there's been too many bodged and burnt wires. So I have decided I am going to rebuild the harness with new wire and connectors. My question is, what is all the nasty thick brown grease that is packed in it inside and out? I've read its anywhere from Dielectric grease to axle grease. I'd like to seal it back with whatever it was by stock and if that's not available what else could be used to seal it from the weather? Thank you
Logged
1978 Trans Am

Jack

  • Oracle Forum Member
  • *
  • Posts: 12429
  • 1971 Esprit TA Clone W72 1972 Formula 68 350 HO
Re: Bulkhead Connector Question
« Reply #1 on: November 11, 2022, 02:24:37 PM »
I would use dielectric grease.
Logged




Regards, Jack

Wallington

  • Oracle Forum Member
  • *
  • Posts: 2238
Re: Bulkhead Connector Question
« Reply #2 on: November 11, 2022, 08:18:09 PM »
It's a gunky sealant. No point spraying degreaser about only to remove it all and let the water in.
Logged

NY81TTASE

  • Active Forum Member
  • *
  • Posts: 736
  • '81 turbo trans am SE
Re: Bulkhead Connector Question
« Reply #3 on: November 12, 2022, 04:14:31 PM »
We use this at work. We call it elephant doo doo^. This is gray but I'm not sure if it comes black, if color matters to you
Or you can search buryl sealants

Ideal Industries 31-601 Duct Seal 1 lb Dark Putty Gray https://a.co/d/aNuFG7e
« Last Edit: November 12, 2022, 04:16:14 PM by NY81TTASE »
Logged
1981 turbo trans am se

Re: Bulkhead Connector Question
« Reply #3 on: November 12, 2022, 04:14:31 PM »
You can help support TAC!
Pages: [1]
« previous next »