TAC Tech > Exterior
Wheel flare protection
b_hill_86:
I took a shot at covering my rear flares with what material I had left since those take a worse beating than the fronts and are a bit smaller. Much better this go around. I started by cutting a template out of construction paper. Slightly thicker actually. I verified it would work for both sides and traced the design on to the material I had left.
Once I cut it out I wet the flare down with a soapy water solution and began applying. This time it seemed to adhere much better and I was able to maneuver it around a bit.its not perfect but I’m pretty pleased with the outcome
These are before pics
b_hill_86:
After
FormTA:
Not bad! They look pretty good and you wouldn't notice them if you weren't looking for it!
I like it.
b_hill_86:
Thanks I’m pleased overall I think. I could’ve done something different with the top edge of the film such as extending it further up or cutting it at a different angle but I wasn’t sure how easy it would adhere and you’re right, I don’t think anyone will notice if they’re not looking for it.
Navigation
[0] Message Index
[*] Previous page
Go to full version