TAC Tech => Mechanical => Topic started by: MalteseFalcon on April 03, 2021, 02:15:15 PM
-
Howdy.
Would anyone happen to know what hardware is used to hold the heat shield onto the exhaust crossover on the 1971 - 72 455 HO aluminum intake manifold set up? I have an original manifold and cross-over, and ordered the heat shields from Ames, but they don't come with hardware.
Picture for reference:
(https://i.imgur.com/WIQwI6v.jpg)
Also, what is the correct finish for the heat shields? They come in a kind of grey paint, which could be primer. I would think that the originals would have been plated, but I'm not sure.
-
I think the anchors were called rivets.
They look like cut nails.
Darryl
-
Rivets.
-
Perfect, thank you! That makes a lot of sense.
Do you happen to remember how the heat shield was finished? I would expect some kind of tin plating, like on the exhaust heat risers?
-
Like the heat risers that cover the exhaust manifolds. Hope that helps.
-
Like the heat risers that cover the exhaust manifolds. Hope that helps.
Like this:
(https://i.imgur.com/bewbgjA.png)
That does help! Thanks!